![]() ![]() Some time after his famously long and ultimately successful battle with automakers to be compensated for his invention, Kearns heard that his boyhood Catholic church, Our Lady of Lourdes in River Rouge, near Detroit, was to be demolished. It’s a long story - just about everything at Second Chance is - so here’s the short version: Throughout his life Kearns believed he was guided by a divine presence. So I’ll begin at the entrance: The statue of the angel visiting Jesus in the Garden of Gethsemane and the marble angels to either side - all of that came from the Michigan church where the late Robert Kearns, inventor of the intermittent windshield wiper, worshipped as a boy during the Great Depression. Find out more about cabinets.When it comes to describing Second Chance and its vast operation in South Baltimore, I hardly know where to begin. These will make sure everyone can see what is on display in the wood display case. #Curio cabinets with glass doors installExcellent addition to installing glass in a wood display case is to install sufficient lighting and glass shelves. A great wood curio cabinet should display what is inside the case. The key to building a curio cabinet is to ensure that plexiglass is used in most of the panels and doors. After this step, all you need is an interesting collection to complete the project. You can have two coats of polyurethane for a beautiful finish. You may also put a light on the top for a warm appearance. You may choose to put glass shelving within. Install the handle and magnetic latches and attach the shelf pins and glass shelves.Do three sides, then slide the glass in, and attach the fourth side. They are cut at 45-degree angles and screwed together. It would be best if you cut a groove on the inside of each piece for the smooth sliding of the glass. Cut them to length and then rip to width. Next, build the doors with barn siding.You may also buy readily-cut plexiglass for safety. ![]() Hold it close by the blade, so it does lift while you cut it and use a full-face shield to protect yourself. Carefully cut the plexiglass on the table saw.This method is more stable than merely attaching the shelves flush with the sides. Then use wood screws from the outside for fastening. ![]() On the two sides, make dado cuts or grooves across the shelves’ width to slide in.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |